This website uses cookies
This website uses cookies. For further information on how we use cookies you can read our Privacy and Cookie notice
This website uses cookies. For further information on how we use cookies you can read our Privacy and Cookie notice
In stock
10offers starting fromKSh 682
See More OffersShipped from abroad
Easy Return, Quick Refund.Details
WorldDeal
88%Seller Score
478 Followers
Shipping speed: Good
Quality Score: Excellent
Customer Rating: Good
Features:
PWM converts digital signals into analog signal (0 to 10V).
Input digital signal can be 5V or 24V level 0-100% PWM signal.
Output analog signal can be 0-10V voltage.
Can be used for industrial control panel PLC or other signal interface switching.
This module is easy to wire and convenient to use.
Specification:
Condition: 100% brand new and high quality
Current: Max. 12mA
Power supply input voltage: 12-30V
Size: Approx. 5 x 4.5cm / 1.97 x 1.77inch
Weight: 20g
Quantity: 1pc
Using method:
PWM signal input frequency range: 1KHZ-3KHZ
PWM signal input level range:
4.5V to 10V peak to peak level, jumper inserted at 5V. This type signal mainly for conventional industrial control card (such as for MACH3 board), for 5V the CPU interface.
12 to 24V peak to peak level, jumper inserted at 24V. This type signal mainly for conventional PLC interface
0-10V analog voltage output explanation:
When the signal input port is not connected, the output port gives 0V. The first time when we power on this module, we better calibrate it: find a 50% duty ratio signal, connect to DIN-, DIN+, the amplitude matches corresponding jumper. When frequency is at 1kHz ~ 3kHz, use a multi-meter to test AO, GND. The meter should be showing around 5.4V. We adjust the potentiometer on the converter module to make multi-meter shows about 5.4V. After this is done, we have calibrated and matched pulse signal with this converter module. The module has a definition of 0.1V. Output current 10mA. If duty ratio is in opposite to voltage, we can select PWM output pin STEP LOW / ACTIVE for MACH3 software.
Package Included:
1 x PWM Signal to Voltage Converter
Note:
After power-up, when there is no input signal, the output is 0V. There is output only when there is input.
.
This product has no ratings yet.