433Mhz e Control Wireless Switch DC 12V 1CH RF 10A Relay Receiver and 2CH nsmitter For Door Electroic Lock

Input Voltage: 12 V, RF working mode: rheterodyne

• Receiver sensitivity: > 97 dbm

• nsmitting distance:> 100 m open space

• De mode: MCU de

• e storage: 20

• Support e type: EV1527 learning code

• Working mode: Momentary, tole, latching time delay 5s ,10s ,15s

• Output terminal: NO , NC , COM

• e control battery: 2 x 3 V CR2016 on batteries

Note: Maximum input power is 250 V

e prograng

Working mode:

1. Inching mode: press the e control the relay will connect, and then release the e controlto disconnect the relay;

2. S-locking mode: press the e control the relay will connect, and then press the e control again to disconnect the relay;

3. Interlomode: press the e control key A to connect the relay, and press the e control key B to disconnect relay.

4. Delay mode: press the e control the relay will connect, release the e control and start timing. After 5S, 10S and 15S 3 gears, the relay will be automatically closed.

Learning Methods:

1. Inching learning method:

Press the code pairing on on the control panel once, and the LED indicator will f once. After the LED indicatorlit, press the on you need to pairing on the e control, the LED indicator on the control panel will f for 3 times which means the pairing succeed.

2. S-locking learning method:

Press the code pairing on on the control panel twice, and the LED indicator will f twice. After the LED indicatorlit, press the on you need to pairing on the e control, the LED indicator on the control panel will f for 3 times which means the pairing succeed.

3. Mutual lolearning method:

Press the code pairing on on the control panel three times, and the LED indicator will f three times. After the LED indicatorlit, press the on you need to pairing on the e control, the LED indicator on the control panel will f for 3 times which means the pairing succeed.

4. 5S delay learning method:

Press the code pairing on on the control panel four times, and the LED indicator will f four times. After the LED indicatorlit, press the on you need to pairing on the e control, the LED indicator on the control panel will f for 3 times which means the pairing succeed.

5. 10S delay learning method:

Press the code pairing on on the control panel five times, and the LED indicator will f five times. After the LED indicatorlit, press the on you need to pairing on the e control, the LED indicator on the control panel will f for 3 times which means the pairing succeed.

6. 15S delay learning method:

Press the code pairing on on the control panel six times, and the LED indicator will f six times. After the LED indicatorlit, press the on you need to pairing on the e control, the LED indicator on the control panel will f for 3 times which means the pairing succeed.

-Clearing the code :

Push the learning on on the receiver 8 times , the codes will be reset.

After clearing the code, will be need to be recalibrated

Package including

1*Receiver module

1*e Control with battery