F4 V3S PLUS Flight Controller Professional Flight Control B

Feature:
1. Copper Sheet: The PCB adopts high end 8 layer thickened copper sheet, which has strong current transmission capacity and great heat dissipation.
2. Great Performance: Adopt high current resistance MOS, long life and strong load capacity. Using industrial grade LDO, high temperature resistance, reliable for use.
3. Scope Of Application: With gyroscope, barometer and other functions, higher controllability and playability. Suitable for FPV dr-one and quadcopter.
4. Support Function: Support for drag and drop OSD configured via for Betaflight, SBUS or PPM and Spketrum for DSMX ports, micro storage card black box.
5. Accessory Set: Reasonable and precise design, important and necessary accessories for quadcopter, equipped with wiring and rubber pad, easy to connect and use.

Specification:
Item Type: Flight Controller
Material: Electronic Components
Colour: Black
Product Size: Approx. 36 x 36mm / 1.4 x 1.4in
Installation Hole Distance: Approx. 30.5 x 30.5mm / 1.2 x 1.2in
MCU: STM32 F405
Support Function:
Drag and drop OSD configured via for Betaflight
SBUS/PPM and Spketrum for DSMX ports
Micro storage card black box
Gyroscope: BMI270
Barometer: BMP280
BEC: 5v3a 9V3A
Applicable: FPV dr-one, quadcopter.

Package List:
1 x Flight Controller1 x Wiring4 x Rubber Pad
Note:
1. The flight controller has many integrated functions, and the components are very dense. When installing, please do not use tools (such as needle nose pliers or sleeves) to tighten the nuts, which will easily scratch the flying tower hardware and cause unnecessary losses. The correct way is to press the nut with your fingers, and a screwdriver can quickly tighten the screw from the bottom. (Remember not to be too tight, so as not to damage the PCB board)2. Do not install the propeller when installing and debugging the flight controller, try not to test the flight indoors, so as to avoid safety accidents. Before installing the propeller for a test flight, please double check that the direction of the motor and propeller is correct. Safety Tip: Do not fly near crowds.3. Do not use non original aluminum or nylon columns to avoid damage to the flight controller hardware. The official standard is a custom sized nylon column to fit the flight controller.4. Before the aircraft is powered on, please check again whether the installation between the flight controller plugs is correct (the pins or cables must be installed in alignment), check again whether the positive and negative poles of the welding are correct, and check whether the motor screws are against the motor stator to avoid short circuit.5. Check whether there is solder thrown out on the original flight controller electronics, which may cause a short circuit.