1 Channel Way DC 5V 12V 24V 30A High Power Relay Module With Optocoupler Isolation H/L Level Triger For Arduino

Package : TQFPis_customized : YesModel Number : 1 Way Relay ModuleOperating Temperature : -Dissipation Power : -Supply Voltage : DC 5V 12V 24VApplication : -Condition : NewType : Voltage RegulatorBrand Name : Jessinie : Mainland China Product introduction: 1 way 5V 12V 24V relay module series relay module, using patch optocoupler for isolation, stable performance, user-friendly design, select high-level or low-level signal trigger, only 5mA current can drive the control capacity of 30A The relay is closed, and the module adopts genuine high-quality power relays, small package optocouplers, high-power high-voltage transistors, red and green signal indicators, and military-grade double-sided PCB boards. The layout is considered comprehensive and the performance is stable. It is suitable for all kinds of single-chip control. It can be widely used in various power control occasions.   Product : Module size: 50mm * 33mm* 24mm (length * width * height) There are 4 fixing bolt holes, the hole is 3.1mm, the spacing is 44.5mm*27.5mm   Parameter:   5V Relay module Quiescent current: 5mA Maximum current: 190mA Trigger current: 2-4mA Trigger power (low): 0-1.5V High: 2.5-5V   12V Relay module Quiescent current: 5mA Maximum current: 80mA Trigger current: 2-4mA Trigger power (low): 0-4V High: 4.5-12V   24V Relay module Quiescent current: 5mA Maximum current: 50mA Trigger current: 2-4mA Trigger power (low): 0-8V High: 8.5-24V   Pin description: 1. DC+: Module DC power supply anode (trigger terminal voltage anode) 2. DC-: Module DC power supply negative electrode (trigger terminal voltage negative electrode) 3.IN: Signal trigger terminal (default trigger voltage is the same as power supply) 4.JD+: Positive voltage of relay control terminal 5.JD-: The negative pole of the control terminal voltage of the relay 6. Short-circuit DC+ and JD+ with jumper caps, and short-circuit DC- and JD- with jumper caps. The trigger terminal and the relay control terminal have the same voltage 7. High and low level trigger mode selection, as shown in the figure, when the jumper is connected to the L terminal, the IN terminal is a low level trigger, and when it is connected to the H terminal, it is a high level trigger 8. Normally closed terminal (NC): normally closed terminal of the relay 9. Common terminal (COM): relay common terminal 10. Normally open terminal (NO): Relay normally open terminal