150A Hall Current Sensor HCS-150A For FPV Flight Controller

Detailed Information About The Product:

Hall effect current sensor
No voltage drop and heat on current sensor components
Offset and Sensitivity are calibrated in factory
Made of high-quality materials, sturdy and durable
Easy to use

Offset and sensitivity are factory calibrated
Continuous current rating: 0~150A DC
Sensitivity: 20mV/A, INAV/BF ratio = 200, ArduPilot BATT_AMP_PERVLT = 50
VBAT voltage sensing: 0~69V, INAV ratio = 2100, BF ratio = 210, ArduPilot BATT_VOLT_MULT = 21.0
Power consumption: 17mA
Voltage offset error at zero current: +-10mV
Current output voltage error: 5%
Operating temperature: -30~80 °C
Vbat: for voltage sensing, supports 0~69V IN
Voltage: = 1/21 Vbat, 0~3.3V output
Current: current signal, 0~3.3V output
5V: HCS-150A board power supply, supports 4~13V Input, 17mA
G: GND
TX/RX: For firmware update and configuration (to be supported)
Tip: Hall sensor should be installed away from iron and magnetic materials
(Due to different batches, the printed words on the product will be different, which does not affect use)
Material: PCB
colour: As shown

Package Contents:
1 x Hall Current Sensor

Only the above package content, other products are not included.
Note: Light reflection and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.