2pcs/1pc XL63070 TPS63070 DC Automatic Step Up Down Power Boost Buck Module 3.3V 5V 9V Low Ripple Lithium Voltage Stabilization

Module type: DC automatic voltage rise and fall power supply

Starting voltage: 2.8V (After starting, the module can output positive E normally within an input voltage of 2V-9V)

Input voltage: 2V -16V

Output voltage: 2.5V -9V

Output current: 2A (MAX). The output MAX current at different voltages can refer to "Table 1"

Working mode: PWM/PFM

Output ripple: 10mV (9V), 8mV (5V), 8mV (3 3V)

(Note that the ripple data above is for reference only and is not included in the sample's no-load test.)

There may be slight differences between the same chips, and the carrier ripple can refer to "Table 1"

Adjustment method: Jumper pad selection




VIN

Power input positive pole (2V-16V)

GND

Power input/output negative pole

VOUT

Power output positive pole

EN

Enable control (default enable, pin down is disabled)

PS

Mode configuration, default PWM mode, short circuiting pads in PFM mode

Output voltage selection, short-circuit output 9V

5V

Output voltage selection, short-circuit output 5V

3.3V

Output voltage selection, short-circuit output 3.3V

ADJ

Output voltage configuration, user can configure resistance to adjust output voltage by themselves





window.adminAccountId=244722939;





">