DC Motor Speed Governor 12 V24v36v48v High Power Driver Module PWM Controller 20A Current Regulator

250Pcs Per Piece:52*30*38cm，18.5kg

DC Motor Speed Governor 12 V24v36v48v High Power Driver Module PWM Controller 20A Current Regulator

Technical indicators

 
Input Voltage: DC10-60V Output Voltage: Linear under Load
 
Output Limit Current: 20A (Use Within 10, 450W for a Long Time, Pay Attention to Keep the Module Unobstructed Heat Dissipation Conditions)
Limit Power: 1200W
 
Speed Regulation Type: Flow Regulation Speed Regulation Mode: Potentiometer (LINEAR)
 
Speed Control Duty Cycle Range: 0 -- Control Frequency: 25KHz
 
Wiring Type: Fence Type Wiring Terminal Knob Line Length: 20cm
 
Module Size: Length * Width * Height 77mm * 45mm * 28mm Product NET YIELD: 73G
 
Motherboard Installation Size: Length * Width 73mm * 40mm Potentiometer Installation Hole: 7mm
 
Wiring Diagram
Make Sure That the Positive and Negative Connections Are Correct before Power on. Do Not Touch the Wiring Cooling Fin, Which May Burn the Circuit Board. Note That This Is Not a Power Module. You Must Connect the Motor to Adjust the Speed. If You Do Not Connect the Motor, the Multimeter Output Will Not Change.
Input: DC Within 9-60v
电源:POWER POWRE-
电机:MOTOR MOTOR-

Note:

1. This Speed Controller Is Used for DC Brush Motor.

 

2. It Is Not Suitable for Speed Regulation of DC Brushless Motor; Nor Can It Be Used as Pressure Regulator Or Voltage Regulator!