DC10~60V DC 10~60V Motor Speed Control PWM Motor Speed Controller Switch 20A Current Voltage regulator High Power Drive Module

Technical indicator

Input voltage: DC10-60V Output voltage: linear under load

Output limit current: 20A ( 10A for a long time, within 450W, pay attention to keep the module bstructed heat diation conditions)

Limit power: 1200W

Speed regulation type: current regulation speed regulation mode: potentiometer (linear)

Speed control duty ratio range: 0 -- control frequency: 25KHZ

Wiring type: fence type wiring terminal knob Wire length: 20CM

Module size: length * width * height 77MM*45MM*28MM Product net: 73 gram

According to the installation size of the : length * width 73MM*40MM potentiometer according to the installation hole: 7MM

The wiring diagram

e sure the positive and negative connections are correct before powering on, and do not touch the heat sink, which may the circuit board. Note that this is not a power module, you must be connected to the motor to speed, without the motor output does not change.

The input is 9-60V internal DC

POWER supply: the POWER + POWRE -

MOTOR: the MOTOR + MOTOR

Please note:

1. This type of governor is d for dc brush motor.

2. Not suitable for speed regulation of brushle DC motor; Can not be d as a voltage regulator or regulator!