Diymore XL6019 DC-DC Auto Adjustable Buck Boost Module 5V-32V To 1.2V-35V Step Down Up Power Supply Module 12V 24V For Arduino

Diymore XL6019 DC-DC Auto Adjustable Buck Boost Module 5V-32V to 1.2V-35V Step Down Up Power Supply Module 12V 24V for Arduino



XL6019





Product introduction:


Module nature: non-isolated buck-boost module
Input voltage: 5-32V
Output voltage: continuously adjustable (1.2-35V)
Output current: 1.5A (MAX)
Input current: 4A (MAX)
Output power: natural cooling 20W, plus heat sink 25W (MAX) actual power
Maximum output power = input voltage * 4A * conversion efficiency
Output ripple: input 12V output 24 0.5A ripple 30MV 20M bandwidth (for reference only)
Working temperature: industrial grade (-40°C to +85°C) (the ambient temperature exceeds 40°C, please reduce the power to use, or strengthen the heat dissipation)
Full load temperature rise: 45℃
Working frequency: 400khz
No-load current: typical 15mA (5V to 12V)
Load regulation rate: ±0.5%
Voltage adjustment rate: ±0.5%
Dynamic response speed: 5% 200uS
Enable control port: Yes, high level 1.4V-VIN (ON), low level 0-0.8V (OFF), default high level
Short-circuit protection: None (please install a fuse or protection circuit in the input)
Input reverse connection protection: No, please cooperate with our reverse connection protection board or connect a diode in series with the input.
Installation method: can be screwed (fixed hole 3 mm), 2 fixed holes
Wiring method: soldering, after adding pins, it can be soldered directly on the PCB




Package Included:


1 x XL6019 Automatic Buck-Boost Module


XL6009

Technical Parameters:
Model specification: automatic step-down module
Module attributes: non-isolated buck-boost
Rectification: non-synchronous rectification
Input range: 3.8V ~ 32V
Output range: 1.25V~ 35V
Input current: 3A (maximum), no-load 18mA (5V input, 8V output, no-load less than 18mA)
The higher the voltage, the greater the load current.
Conversion efficiency: