FREE Electric Scooter Parts Repair 66 LCD Display with SM 5Pin 6Pin Plug Accessory For E~Bike Display Meters Acesssories

Note:

Not Universal Model .Please checked and confirmed yours controller support same communation protocol UART NO.2 ,if not same ,The LCD screen will be show Error Core E10 （Communications Receiving Fai）Used Our Store Controller.

Type:FOCAN- LCD display

Condition: 100%

Model :66

Voltage:24V 36V 48V 60V adjust By P03 set on screen

Color:Black

Material: Plastic+Acrylic

Operating Temperature :-20 - 45℃

Handlebar size for holding:Φ22.2mm

Plug Type:

SM 5pin Connector (LCD cable )+ SM 2pin connector (Light cable)  -180cm

5Pin /6Pin Male Waterproof Pug -25cm

5Pin Female Waterproof Plug -150cm

Communication Protocol:UART NO.2(Note:The product is based on the No. 2 communication protocol and needs to be used with the controller of the No. 2 communication protocol, otherwise it is not compatible.)

Display Funcation :Speed Display, Battery Level Display, Error Indication, Total Mileage, Single Mileage

Note: Due to product upgrade, the product you purchased may be slightly different from the descrtions in this user manual, and this won’t affect normal usage.

Package List:

1 x LCD Display

P setting：

P01: Backlight brightne (1: darkest; 3: brightest)

P02: Mileage unit (0: KM; 1: MILE)

P03: Voltage level: 24V/36V/48V/60V (default)/36V

P04: Sleep time (0: never, other numbers refer to sleep time) Unit: minutes

P05: Auxiliary: 0,3 gears 1gear2V, 2gear3V, 3gear 4V1st, 5th gear 1st gear 2V, 2nd gear 2.5V, 3rd gear 3V, 4th gear 3.5V, 4th gear 4V

P06: Wheel diameter unit: inch Accuracy: 0.5

P07: steel number (1-100)

P08: Maximum speed limit unit: KM/H

P08: Speed limit: the range is 0-50 km/h, 50 means no speed limit.

1. Non-communication state (instrument control): the speed is turned off PWM output Greater than the set speed; automatically turn on the PWM output when the speed is lower than Set the speed, the current speed is (+1km/h); (close the speed limit Booster only.）

2. Communication status (controller control): The drive speed is kept at the set value.Error: +1km/h; (average speed limit of booster and steering gear)

Note: The value here is in kilometers. When the unit setting is changed from kilometers to miles, the speed value of the display interface will be automatically converted to the correct value mile. However, the speed limit data set in the menu under the mileage interface will not be converted.It does not match the actual speed limit mileage value.

P9: zero start, non-zero start setting, 0: zero start; 1: non-zero start

P10: The drive mode is set to 0: boost drive (determine how much power is required by the boost gear output, the switch is invalid at this time).

1: Electric drive (rotate the driver, the booster gear is invalid at this time).

2: Power-aisted drive and electric drive coexist at the same time (zero-start state of electric drive is invalid).

P11: Auxiliary sensitivity setting range: 1-24

P12: Boost start intensity setting range: 0-5

P13: Set booster type to 5, 8, 12 s

P14: Controller current limit setting default 12A range: 1-20A

P15: No present

P16: ODO reset setting Pre and hold the on for 5 seconds to clear ODO