Home Security Alert Infrared Sensor Motion Anti-theft Warning Alarm Wireless Remote Control System for Door

Product description:

This remote control infrared alarm is a set of infrared detector and alarm in one, with wireless remote control to form an alarm system. Once the infrared detector detects an illegal human movement intrusion, it immediately activates a high-decibel siren to emit a 30-second on-site alarm sound, which plays a powerful deterrent role. The alarm uses a special infrared sensor processing chip, PIR dual element pyroelectric infrared sensor. By detecting the infrared thermal energy radiated by the human body, the on-site audible alarm of the probe is activated to prevent theft in time. It is an ideal anti-theft facility for various vehicles, homes, shopping malls, offices, courtyards and storefronts along the street. It is an indispensable anti-theft product for modern families, shops, enterprises, institutions and businesses in hotels.

Features:
1. Infrared detection
2. Long-distance multi-channel wireless remote control, equipped with two remote controls.

Technical Parameters:
Alarm sound level: 105dB (decibels)
Remote control distance: about 5-10 meters (open area)
Detection range: detection distance of about 7 meters

Working voltage: AC 220V (requires self-equipped transformer), DC 6V (4 batteries AA supplied) consumes very little power

Installation requirements:
◆The remote infrared warning device should face the protected area directly without obstacles.
◆When installing, the infrared warning device should be far from hot and cold sources, such as hot and cold air outlets, air conditioner air outlets, electric heaters, coolers, etc.
◆The remote infrared alarm should be at an angle of 10 to 30 degrees with the wall. This is the maximum detection distance. Adjust the installation angle according to the situation during installation.
◆Because the remote infrared warning device has the highest infrared detection sensitivity when the human body moves laterally with respect to the lens, the angle and height of the horizontal plane of the detector should be paid attention to during installation.

Brief introduction:
After the installation, the switch is turned on, the owner can leave the sensing area within a short time, the PIR enters the working state in about 15 seconds, and someone passing the sensing area will cause an alarm to sound. No sound will be produced when it is turned off. Sensing range: horizontal angle is 110 degrees and vertical angle is 35 degrees. The sensing area is normally around 7 meters, the sensing distance and sensing area range can be adjusted according to your needs. When you press the remote control button during use, the host beeps once, indicating that you are in the armed state. After a delay of about 10 seconds, if someone is detected in the armed area, it will immediately alarm for 30 seconds at high loudness. To disarm the PIR, press the remote control button, it will beep once meaning it has entered the disarmed state. To silence the alarm, press the button once.

Precautions:
●When the remote control distance is shortened, replace the battery.
●When using battery, regularly check whether the battery leaks.
●It is recommended that you regularly check whether the infrared alarm is working properly to avoid missing alarms.
●The detector should be protected from rain, wind, sunlight and indoor heat sources such as air conditioners and stoves.

The packaging includes:
2*Remote controls
1*PIR

4*AA Batteries