Share this product

Impulse Polythene Bag Sealing Machine Heat Sealer-300mm

KSh 4,999

In stock

+ shipping from KSh 90 to CBD - UON/Globe/Koja/River Road

0 out of 5

(No ratings available)

Variation available

...small

Delivery Fees KSh 90

Ready for pickup between 24 November and 26 November if you place your order within the next 10hrs 30mins

Delivery Fees KSh 200

Ready for delivery between 24 November and 26 November if you place your order within the next 10hrs 30mins

Easy Return, Quick Refund.Details

Mustard enterprises

80%Seller Score

11 Followers

Shipping speed: Good

Quality Score: Excellent

Customer Rating: Poor

1.The machine without power switch. The AC power cord into the outlet, according to the thickness of the material to be sealed, adjust the heating time. The plastic on the sealing surface, then press the handle, the circuit is automatically controlled heating time. When the light is off, the power is automatically disconnected. After about 1-2 seconds, release the handle on a good seal.
2.The square when an access point appears damaged seal, it is because the heating time is too long, please dial anti-clockwise rotation to shorten the heating time.
3.If the seal is not strong, it is because the heating time is too short. Keep the knob clockwise to extend the heating time.
4.If a plastic bag stuck to the rubber plate, indicating the cooling time is not enough, we must extend the cooling time after the light goes out. Please release handle a little bit late.
5.Adjust heating time later, in use should remain unchanged, in continuous use do not have to make any adjustment

1.The machine without power switch. The AC power cord into the outlet, according to the thickness of the material to be sealed, adjust the heating time. The plastic on the sealing surface, then press the handle, the circuit is automatically controlled heating time. When the light is off, the power is automatically disconnected. After about 1-2 seconds, release the handle on a good seal.
2.The square when an access point appears damaged seal, it is because the heating time is too long, please dial anti-clockwise rotation to shorten the heating time.
3.If the seal is not strong, it is because the heating time is too short. Keep the knob clockwise to extend the heating time.
4.If a plastic bag stuck to the rubber plate, indicating the cooling time is not enough, we must extend the cooling time after the light goes out. Please release handle a little bit late.
5.Adjust heating time later, in use should remain unchanged, in continuous use do not have to make any adjustment