Infrared Anti-theft Motion Detector Security Portable 105dB PIR Motion Detector Home Security Alarm System+2 Controllers SHIELD

Infrared Anti-theft Motion Detector Security Portable 105dB PIR Motion Detector Home Security Alarm system+2 controllers

 

Instructions:

1. Install the battery, use the remote control to open the alarm host, the green light is on for about 20 seconds, this 20 seconds is the power-on delay time, you can leave the infrared alarm detection area within 20 seconds. 2.After 20 seconds, the power-on delay time ends, the green light goes out, and the infrared alarm enters the alert state. 3.If a person enters the detection area of ​​the infrared alarm at this time, the red light on the left of the green light will begin to flash for 5 seconds. This 5 second delay is for the convenience of the owner to promptly turn off the alarm so as to avoid unnecessary alarm sounds. 4.After 5 seconds, if the host does not receive a signal to turn off the alarm, even if the intruder has left the detection range, the alarm host will still emit a harsh alarm sound that grows for 30 seconds. The alarm volume is 105 decibels. 5 seconds after the end of the alarm sound, if another person walks within the detection range, it will alarm again and start again. 5.When the infrared alarm sounds, you can use the remote control to turn off the alarm switch and end the alarm.   Notice: 1, the probe can not be installed outdoors, it should also avoid direct to the outside, so as to avoid false alarm caused by wind and rain sun and other reasons 2, probe should be away from cold and heat sources, such as air conditioning outlet, heating, air conditioners, stoves, etc. 3, should be avoided when installing and using the sun, car light direct probe.   Package included: 1 X Wireless alarm detector (Batteries and Power Adapter not including)  2 x Remote Control