LED Solar Street Light-fake Camera

2 in 1 Fake Solar Light Camera: Comes with 77 bright, motion-activated LEDs. Coupled with the realistic virtual camera, when the lights are turned on at night, the small red light flashes periodically to serve as a warning.
3 lighting modes:①Human body detection mode (the highlight light turns on when a person passes and turns off 20-30 seconds after the person leaves);② Human body detection + low light mode (low light at night, high brightness when people pass by, low light for 20-30 seconds after people leave;③ Low light mode (the light is always in low light state).Remote control: Use the remote control to control the light on/off and adjust the lighting mode, which is very convenient to install anywhere.
Solar light adjustment angle: vertical 90°, horizontal 360°, rotation adjustment angle.Built-in PIR Motion Sensor: The light will automatically trigger when motion is detected at night within 9.8-16.4 feet, within a range of 120 degrees.Wide application: IP65 weatherproof, suitable for all weather conditions. Perfect for outdoor lighting, it can illuminate your garden, patio, front door, yard, walls and more.
Battery specifications: KHTO 18650 3.7V 1200MAH lithium battery with charge and discharge protectionInput voltage: 5.5VTotal power: 50WLight source: KHTO solar lampNumber of LEDs: 42 SMD2835Luminous color: whitePower supply: 1 x 3.7 V 1200 mAh lithium battery.Charging time: 6 hours in the sunWorking hours: more than 10 hoursControl mode: light/PIRHighlight delay: 20-25 secSensor angle: 120°Sensor distance: 3MProtection level: IP65Material: ABS --ItemWhite colorLamp size: 14.7*8.2*8.5cm (length*width*height)Package weight: 250g
Note: The simulated camera makes this solar light look like a real camera. Not a real camera.

Particular attention is required:1. Check if the switch is on.2. It is a light sensor, it cannot work during the day and can only work in the dark.3. Confirm whether it has been used continuously for a long time without charging. Please charge it in time before using it.4. Make sure people move around heat-sensitive areas.5. Make sure the solar sensor light is installed within the detection range.6. Confirm that the installation direction is correct (solar panel facing up).7. Make sure there is no object blocking it and the solar panel can receive sunlight.