Motion Sensor Alarm, PIR Infrared Detector Security Anti-theft System + 2 Remote Controllers for Home, Shops, Garages, 105dB House

A battery-powered, wireless PIR motion sensor alarm designed to protect homes, shops, garages, and other spaces. It features a built-in passive infrared detector that senses movement and triggers a 105 dB siren, with entry and exit delay periods. Comes with two infrared remote controllers for arming and disarming.

This alarm has built in PIR motion sensor that will activate the alarm if any movement is detected. It is ideal for protecting your property against intruders/burglar. It can cover the front door, back door, garage, shed, outbuildings etc. Wireless design make it easy to install, just put the required batteries in, fix to a suitable surface and turn it on with one of the supplied remote control. It can be widely used at house, office, factory, store, even carvans and motor homes.

Wide-angle detection, comprehensive prevention.

30° wide angle up and down, 110° wide angle left and right

Night anti-theft guard security, sound and light alarm to scare off thieves.

Sound loud up to 105 decibels, alarm at the same time the alarm red light flashing, can effectively deter thieves!

About 8 meters range for detection.

Built in PIR motion sensor, it will automatically activate the alarm when the body get close to it.

It can be widely used at house, office, factory, store, even caravans and motor homes.
Power Supply    4 * AA Batteries (FREE INCLUDED)

The remote controller power by 3 AG13 batteries(Included)
Sound    105db alarm

How to use?

1. Turn on the power.

2. A green light will light up for about 20 seconds. During this period you may move around without triggering the siren. This gives you a chance to leave the room without triggering the alarm.

3. After 20 seconds, the green light will go out and the unit is in motion detect mode. At this point any motion within 5 m will trigger the siren. Once triggered, the 105db alarm will blare non-stop for 45-50 seconds and then re-sets itself to motion detect mode.

4. After the siren, you can turn off the power.

Installation Method:

1. Fasten the socket on place 1.4-2 meters from the ground.

2. Open the battery cover, and install 4 AA batteries.

3. Fasten the motion detector on the socket, angle the motion detector's mounting bracket for a precise aim.