MSP6729 Magnetic Rotate Speed Sensor Pick Up Sender Ring 3/8-24UNF-2A Threaded

Introduction:
* The magnetic speed sensor indicates when ring gear teeth, or other ferrous projections, pass the tip of the sensor.
* Electrical impulses are induced within the coil and sent to the speed control unit. The signal from the magnetic speed Sensor, teeth per second(HZ), is directly proportional to engine speed.

Specification:
Material: Plastic
Color: Black
Model: MSP6729
Total Length: 188cm/74"
Thread: 3/8 - 24 UNF Threaded
All are designed and tested to operate within a temperature range of -65°F to 225°F (-55°C to 105°C) .

Package Included:
1 x MSP6729 Magnetic Rotate Speed Sensor

Features:
● The magnetic speed sensor is mounted in the ring gear case or flywheel bell housing of the engine.
● The threaded hole for the speed sensor should be perpendicular to the centerline of the crankshaft and centered
over the ring gear teeth.
● A spot face should be present to provide a flat surface on which to anchor the locknut.
● With the engine stopped, screw the speed senor in until it touches a gear tooth, then back it out 3/4 of a turn and secure it with the locknut.
● Any ferrous gear may be used as long as the frequency and amplitude of the resulting signal meet the speed control unit specifications
● The wire leads should be twisted for their entire length from the magnetic speed sensor to the control unit.
● The leads may need shielding if they are longer than 10 ft. (3m), or if external interference is present.
● Do not connect either of the speed sensor leads to anything but the speed control unit used. The shield should not be connected at the speed sensor end.

Notice:
1.Please allow 1-3cm Length error due to manual measurement.Pls make sure you do not mind before you bid.
2.The color may have different as the difference display,pls understand.

Magnetic Speed Sensors are with Wire Leads

Item	Pickup Length	Thread Length	Lead Length	Thread Size	Drill Size
MSP 6729	2.7	2.25	72.00	3/8-24 UNF-2A	.332