Nrf24l01 Wireless Module Power Enhanced Si24r1 2.4G Wireless Receiving Communication Module

Tips: Generally, 2 One Pairs Are Used, All of Which Are Integrated with Sending and Receiving, but One Can Only Be Transmitted Or Received, and Cannot Be Used at the Same Time!

Nrf24l01 Is a Monolithic Transceiver Chip Operating in the 2.4-2.5GHz ISM Band. Wireless Transceiver Includes: frequency Generator Enhanced Schockbursttm Mode Controller Power Amplifier Crystal Amplifier Modulator Demodulator Output Power Channel Selection and Protocol Setting Can Be Set through SPI Interface Low Current Consumption, when the Transmitting Power Is 6dBm in the Transmitting Mode, the Current Consumption Is 9.0ma. The Receiving Mode Is 12.3ma, and the Current Consumption Mode in the Standby Mode Is Lower.

Supports Six-Channel Data Reception

1. Low Working Voltage: 1.9~3.6V Low Voltage Working

2. High Speed: 2Mbps. Due to the Short Air Transmission Time, the Collision Phenomenon in Wireless Transmission Is Greatly Reduced (the Software Sets an Air Transmission Rate of 1Mbps Or 2Mbps)

3. Multiple frequency points: 125 Frequency points to meet the needs of multi-point communication and frequency hopping communication

4. Ultra-Small: Built-in 2.4GHz Antenna, Compact Size, 15 X29mm (Including Antenna)

5. Low Power Consumption: When Working in Response Mode Communication, Fast Air Transmission and Startup Time Greatly Reduce Current Consumption.

6.Low application cost: NRF24L01 Integrated all the high-speed signal processing parts related to RF protocol, such as: automatic resend lost data packets and automatically generate response signals, etc. The NRF24L01's SPI interface can be connected using a microcontroller's hardware SPI port or simulated using a microcontroller's I/O port. It has an internal FIFO that can interface with various high-speed and low-speed microprocessors, making it easy to use with low-cost microcontrollers.

7.Convenient for Development: Since the link layer is fully integrated on the module, it is very convenient for development. Automatic resend function, automatically detects and resends lost data packets, resend time and resend frequency can be controlled by software   Automatically stores data packets that have not received a response signal. Automatic response function—after receiving valid data, the module automatically sends a response signal without requiring additional programming. Carrier Detection—Fixed Frequency Detection   Built-in hardware   CRC   Error Detection and Point-to-Multipoint Communication Address Control Packet Transmission Error Counter and Carrier Detection Functions Can Be Used for Frequency Hopping Settings Can Set Six Receiving Channel Addresses Simultaneously, Selectively Turn on Receiving Channels Standard Pin Dip2.54MM Pitch Interface, Convenient for Embedded Applications