Professional Front Parking r Kit Prefix Concealed built-in flat Parktronic istant System Alarm Not Backup

Profeional Car Parking The built-in flat r is very nice-looking, just like the part of the car.Automotive profeional front-end productsDifference 1:The profeional front can still work for about 10 seconds after power fai.When braking, the r starts to work. When it detects obstacles, the system starts to alarm; when the brake is released, the main power of the system is disconnected. At this time, the main board discharges the power, and the r continues to scan for 10 seconds and then stops. In order to e the driver turn or change lanes in small ps, release the brakes, and get the warning of the parking r during the reing proce.For example, the driver activated the front at position 1, and when car reached position A, the car's speed was already slow. At this point, the driver will no longer brake, and the power to the will be disconnected. However, the product will continue to operate for about 10 seconds to detect and alarm at locations B and C.Difference 2:Smart start: When the r does not detect an obstacle, the front vehicle does not start, so as to prevent the light from the display from affecting driving safety.

Difference 3:

A profeional front-end should have a range of around 1.5 meter, as the driver can clearly see obstacles beyond 1 meter

As shown in the following figure: When waiting for a red light, if a usele alarm is generated due to the distance g too far, it may sound annoying

Installation diagram

White-----brake light positive

Black-----GND

Red ------ ACC+

Two conditions for the operation of front-end

1: When braking

2: When the r detects an obstacle

When the distance is 1M~1.5M, it is a safe distance. The display only displays numbers and does not generate an audible alarm to avoid disturbing the driver.When the distance is 0.3M~1M, it is the warning distance. The display shows numbers and emits a heartbeat sound alarm.  (BI BI.....BIBIBI.....BIBIBIBIBI.....BIBIBIBIBIBIIBIBIB........When the distance is 0.2M~0.3M, the display emits a rapid alarm sound( BIBIBIIBIBIBIBIBIBIBIB............

Product s

1> range: 0.2M~1.5M

2>Rate voltage: 12V DC

3>Rate operating range: 10.5V - 16V DC

4>Rate current: 100mA - 300mA

5>Ulsonic frequency: 40KHz

6>Control moudle working temperature: -30 - 80 celcius degree

7>Display working temperature: -20 - 70 celcius degree

8>r diameter: 22mm

9>Installation mode: ing