S-Pow Wall Light wireless Switch S-Powered e Control No Battery No Wire IP54 Waterproof Indoor Outdoor kinetic switch

Attention:

The e control and receiver must be used together, and cannot be used together with other types of e controls, switches.

The working prince of the s-powered wireless wall switch:

The s-powered wireless switch adds a receiver to the connection between the light and the wire. The switch does not require wiring; there is a s-powered module inside the switch, which converts the kinetic energy generated by pressing into electroic energy, and then into electric drive components. The device emits radio frequency signals. The receiver turns the light on or off when it receives a signal.

Wireless e control s:

Size: 86*88*15.5mm
Working voltage: s-generation
Emission current: +13dBm
Keystroke force: 300+/-50g
Waterproof performance: 1P54
Panel bottom shell: interchangeable bottom shell universal
Standby current: Oua
Frequency: 433.92+/-75KHz MHz（ processing）
e control distance: open area>200M indoor>50M
on life: >200,000 times

Receiver experimental s:

Rated voltage: 95-260V
Relay life: open/close times ≥ 400,000
Resistive load: ≤1500W
Standby power consumption: ≤0.3W
Inductive load: ≤1200W
Working power consumption: ≤0.8W
Capacitive load: ≤1200W
Working temperature: -20C~+70℃℃
Working humidity: ≤80%
Working temperature rise: 15℃

Instruction Manual
1. Set on and off status
press the receiver on for 3 seconds, the indicator light fes once, release the on, press the wall switch once, and the receiver indicator fes once, indicating successful learning.
2. Set the on state only for turning on the light
press the receiver on for 5 seconds, the indicator light fes twice, release the on, press the wall switch once, and the receiver indicator fes once, indicating successful learning.
3. Set the off state only for turning off the lights
press the receiver on for 7 seconds, the indicator fes 3 times, release the on, press the wall switch once, and the receiver indicator fes once, indicating successful learning.
4. Clear the learning status.
press the receiver on for 10 seconds, the indicator light fes 4 times, indicating that all learning e controls are deleted.
5.Short press the receiver on, each time you press it, the relay will turn on or off.

Wireless e control is not required

Cabling without wall can be attached anywhere in the home

No power connection without fear of electric shohazard

Waterproof switch insulation wet hand can also touch away from the danger of

High quality materials are flame retant

PC material has temperature and pressure resistance service life