Slide Potentiometer 10K Linear Module Dual Output For Arduino AVR Electronic Block B10K Double Sliding Potentiometer Switch Modu

Package : Slideis_customized : YesModel Number : Slider Potentiometer SwitchOperating Temperature : Metal FilmDissipation Power : Slide PotentiometerSupply Voltage : PotentiometerApplication : ComputerCondition : NewType : Voltage RegulatorBrand Name : Ziqqucu : Mainland China
Single Sliding 10K
Specification:
Size: 90 * 20 mm
Color: Red
Voltage: 3.3 V, 5 V
Port: analog
Resistance: 10 k
Platform: For Arduino, For MCU, For ARM, and other single chip micro
B103 10K
Specification:
：Model: B103 (B type Linear Potentiometer)
：Resistance Value: 10k Ohm
：Adjustment Type: Slide
：Body Size: 75 * 9 * 6mm / 2.95 * 0.35 * 0.24"(pin not included)
：Shaft Size: 15*4*1.2mm (L* W*T)
：Mounting hole diameter: M2
：Terminals Number: 6
：Channel: Double Channel
：Rated Power: 0.25W
：Resistance Tolerance: ±20%
：Sliding Noise: Less than 68mV
：Resolution: 100%
：Zero Resistance: 2Ω
：Contact Resistance: 5Ω
：Insulation Resistance: 100MΩ
Double Sliding 10K
Specification:
Electronic building block double linear potentiometer module For Arduino mixer linear sliding resistance
Wiring instructions: Connect the main controller to the main controller according to the standard interface of the sensor module. The symbol "G" is connected to the "ground", "V" to "5V" and "S" to the "For Arduino" A0 and A1 pins of the main controller. Burn the test program.
Test program:
void setup ()
{Serial.begin (9600);}
void loop ()
{Serial.print ("NUM1 ---");Serial.print (analogRead (0));Serial.println ();Serial.print ("NUM2 ---");Serial.print (analogRead (1));Serial.println ();}
Open the serial monitor, you can see the value changes with the slider slide change
Only the above package content, other products are not included.
Note: Light shooting and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.