TXG4 1.54Inch Colored Screen Display Single-Hand Remote Con

Detailed Information About The Product:

The remote control is used in conjunction with the receiver board. The wireless transmission signal is strong, and the distance between the remote control and the receiving board should be greater than 20cm when using it. Otherwise, if the distance is too close, it will reach saturation due to the strong wireless signal, and the remote control and receiving board cannot be connected
The receiving board is tested well before send out
The recommended battery is a 7.4V rechargeable battery, and the recommended motor is a 390 motor. It is not allowed to use a 775 large current motor. Two motors are the same specification, and the current cannot exceed 10A
If a high-voltage high rate battery (such as 12V) is used and drives a high-speed and high-power motor (with a load current greater than 8A), it is easy to burn out the receiving board due to excessive power
The receiving board is equipped with a built-in compass chip. Please install it according to the direction indicated on the back of the receiving board, so that the ship can automatically travel in a straight line.

Specification for remote controller:
1.54inch colored screen display
Silicone buttons,and clear button functions
Built-in rechargeable battery 1500mah
Type-C charging port
Long term endurance of 18 hours
Easy selection of 24 fishing points
Distance, power, signal, direction, and status feedback display
Weight for remote controller:about 103g
Specification for receiver board:
Adapted battery: 6V,7.2V,7.4V,11.1V,12V lipo battery(Do not use dry battery,as their poor current output capacity can cause the motor to fail to start)
Adapted motor:380 390 motor
Max output current:10A
Motor interface:single way rated current 10A, peak current 20A
LED light interface:directly connected to the LED light, the circuit board has already connected a 200ohm resistor internally
Communication method:bidirectional communication, power, distance, voltage, wireless signal, GPS signal, status information bidirectional transmission
Control distance:500meters
Remote controller power consumption:80mA
Receiver power consumption:130mA
Weight for receiver board:about 55g
Colour:Black
Material:Plastic

Package Contents:
1 x remote controller
1 x receiver

Only the above package content, other products are not included.
Note: Light reflection and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.