Type-C Charging Port Dual USB Power Bank Power Board Boost Module 2.4a Mobile Power DIY Motherboard 5V

Product Characteristic Parameters

1. Input Interface: Type-c and MicroUSB.

2. Output Interface: 2 One High Quality USB Interface (Low Loss of Large Current),2.4A3, Battery Interface: Support Welding Connection Mode of 3.7V Battery (Full of 4.2V). Rechargeable battery

Electric Current 2.4A.

4 Apple Samsung and Other High-Current Charging Identification IC, Give Full Play to the 2.4A Current Advantage (Mobile Phone to Carry out 2.1A/2.4 High-Current Charging Is Related Protocol)

5. Charge and Discharge Design, Which Can Reach 90%.

6. Ultra-Small Size, 55*19 * 8mm.

Application Considerations

1. the Mainboard Has Been Received. Test It with Charging Plug First to See the Led Light on.

2. in Normal Application, the Battery Is Welded, (the Power Supply Will Be Insufficient If the Wire Is Twisted) and the Battery Is Connected to the Motherboard in Reverse. Pay Attention

3. the Battery and Main Board Line Should Not Be Too Thin, Try to Be Thicker. Can Pass Current. It Cannot Be Too Long, and the Interface Needs Welding.

4. the Battery Can Only Be Connected in Parallel, Not in Series, and the Motherboard Must Be Burned in Series

5. Make Sure That the Battery Is Good. If the Battery Is Fully Charged as Soon as It Is Connected, the Mobile Phone Cannot Be Discharged. Most of the Batteries Are Aged and Discarded. 6. Do Not Add a Protection Board to the Battery. Some Batteries Were Not Originally Used for Power Bank. There Is a Protection Board, Which Will Limit the Current. It May Be Protected to Disconnect the Output If It Exceeds One. 7. The Board Will Be Burnt If It Is Connected in Reverse. There Will Be Traces of Burned IC. This Occurs Only When the Reverse Connection Is Performed. Therefore, the Consequences of Reverse Connection Are Not Borne Here.

8. Type-c Ports Are Only Input and Cannot Be Output.

9. Input Current Refers to the Input Current of the Battery