Voltage Converter Module For PLC MCU Digital To Analog Sig

KSh 573

KSh 1,01844%

2 units left

+ shipping from KSh 110 to CBD - UON/Globe/Koja/River Road

0 out of 5

(No ratings available)

Promotions

Easy and safer payments via the JumiaPay App.

Report incorrect product information

Delivery & Returns

Shipped from abroad

Choose your location

Pickup Station

Delivery Fees KSh 110

Ready for pickup between 02 July and 04 July if you place your order within the next 21hrs 54mins

Door Delivery

Delivery Fees KSh 200

Ready for delivery between 02 July and 04 July if you place your order within the next 21hrs 54mins

Return Policy

Easy Return, Quick Refund.Details

Warranty

None

Seller Information

Williami

84%Seller Score

2 Followers

Seller Performance

Shipping speed: Good

Quality Score: Excellent

Customer Rating: Average

Product details

Detailed Information About The Product:

Name：PWM To Voltage Converter Module 0%-100% To 0-10V for PLC MCU Digital To Analog Signal PWM Adjustabl Converter Power Module
It can be used as signal interface switching for PLC or other industrial control boards. The output voltage is regulated by adjusting the duty ratio of the PWM. The modules are small in size and easy to use in different places.
MCU embedded technology
Easy to operate, fine tuned by potentiometer
Select the PWM signal input level range through short-circuit
The module is smaller, easy to carry and use
Work Voltage:DC 12V-30V; (Greater than 100MA)
PWM Receiver Frequency:1KHZ-3KHZ
PWM signal input level range:
The peak of 4.5V to 10V level. The short cap install in '5V'. This level is used for normal controller or 5V MCU
The peak of 12V to 24V level, so inserted in 24V. The short cap install in '24V'. This level is used for normal PLC controller
Conversion range:0%-100% PWM to 0-10V
Allowable error:5%
GND:Ground
GND:Negative of input signal
VOUT:Output Voltage 0-10V
GND:Output Voltage Ground
Operation instructions:
After power on, without input signal, the output is 0V, so only input can output.
The first time when the power is on, it is best to do a calibration debugging:Input a 50% duty ratio signal to PWM/GND and adjust the relative amplitude short cap. The frequency is 1KHZ-3KHZ, Measured VOUT and GND with a multimeter and it will display 5V. Adjust potentiometer to make sure display 5.00V on multimeter. This will calibrate your pulse signal to this module.
When the frequency changes, the correspondences may be offset and need to be re calibrated.
The output voltage can be adjusted by adjusting the duty ratio.
The accuracy can be controlled by adjusting the potentiometer.
colour:Blue + green
Material:PC+ metal
Package Contents:
1 * PWM to Voltage Converter Module
Only the above package content, other products are not included.
Note: Light shooting and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.