Voltage Stabilizer 2005.0 Motorcycle Rectifier

Voltage Stabilizer 2005.0 Motorcycle Rectifier

1. Weight: 210g
2. Wire length: 25cm
3. Output voltage: 14.5v
Installation precautions:
1. The rectifier should be installed in a location with good ventilation and good heat dissipation. High temperature will be generated when the rectifier is working, and poor heat dissipation will damage the rectifier
2. The installation steps of the rectifier are to connect the AC input line, the positive and negative output are not connected, start the locomotive, measure the positive and negative output voltage, and when the voltage range is reasonable, plug in the positive and negative wires, and then test the positive and negative of the battery or rectifier If the voltage range is unreasonable, stop using it and give feedback. The entire installation process should be recorded and saved.
3. Note that the rectifier should be closely attached to the frame when installing it, which is good for heat conduction. You can also add thermally conductive glue between the rectifier and the frame
4. Do not press other wires between the rectifier and the frame
5. There should be a fuse protection device between the positive outlet of the rectifier and the battery to prevent the rectifier from being damaged and the voltage is too high and other electrical components are burned out
Applicable models:
For SKU254617 5BN-81960-00-00;
For Yamaha XVS1600 ATLER/ATLERC Road Star Silverado Limited
For Yamaha XVS1600 ALER/ALERC Road Star Limited Edition
For Yamaha XVS1100 V-Star 1100 Classic
For Yamaha XVS1600 ASM/ASMC Road Star MM Limited
For Yamaha XVS1600 ATN/ATNC/ATL/ATLC/ATM/ATMC Road Star Silverado
For Yamaha XVS1600 ASP/ASPC/ASR/ASRC Road Star Midnight
For Yamaha XVS1600 ATR/ATRC Road Star Silverado
For Yamaha XVS1600 ASN/ASNC Road Star Midnight
For Yamaha XVS1100 V-Star 1100
For Yamaha XVS1600 AP/APC/AR/ARC Road Star
For Yamaha XVS1600 AL/ALC/AM/AM/AN/ANC Road Star
For Yamaha YXR660 FAHS RHINO 660
For Yamaha S