Xl4015e 5A 4~38V High Power Efficiency DC-DC Adjustable Step-down Module Low Ripple Far More than 2596

Xl4015e 5A 4~38V High Power Efficiency DC-DC Adjustable Step-down Module

This Module Is Different from Lm2596 and Xl4005 Step-down Module on the Market. The Design Power of the Chips Used in This Module Is 15W and 50W Respectively. Our Step-down Module Uses Original Genuine Goods Upgraded Chips, Which Are in the Input and Output Voltage Range, the Output Power and Efficiency Are Better than Similar Products, and the Power Can Reach 75W, Which Has Extremely High Cost Performance.

Module Highlights: 5A High-Power, High-Efficiency, Low Ripple, with Power Indicator, Cooling Fin for Free!!!

Module Performance and Features:

Module Properties: Non-Isolated Step-down Module (Buck)

Input Voltage: 4-38v (Please Try Not to Exceed 38V)

Output Voltage: 1.25-36V Continuously Adjustable

Output Current: 0-5a, It Is Recommended to Use It Within 4.5A

Output Power: It Is Recommended to Use It Within 75W.

Operating Temperature:-40~85 Degrees

Operating Frequency: 180KHz

Conversion Efficiency: up to 96% (Efficiency Is Related to Input, Output Voltage, Current, and Differential Pressure)

Load Adjustment Rate: S(I)≤ 0.8%

Voltage Adjustment Rate: S (U) ≤ 0.8%

Power Indicator: Yes

Short Circuit Protection: Yes (Limiting Current 8A)

over-Temperature Protection: Yes (Automatically Turn off the Output after over-Temperature)

Input Reverse Connection Protection: None, (If Necessary, Enter a Large Current Diode in the Input)

Installation Method: 2 3mm Screw

Wiring Method: Welding, V-IN Is Input, V-OUT Is Output

Module Size: Length 54mm Width 23mm Height 18mm

Weight: 16G

Application Scope:

This Module Can Be Applied in the Step-down Field Where the Input Voltage Is Higher than the Output Voltage, Such as Battery, Power Transformer, DIY Adjustable Regulated Power Supply, 24V Vehicle-Mounted Pen Book Power Supply, Industrial Equipment Step-down, 12V to 3.3V,12V to 5V,24V to 5V,24V to 12V,36V to 24V, Etc.

Please Note:

Some Customers Reflect That the Output Voltage of the Module Cannot Be Adjusted and Is Always Equal to the Input Voltage. When You Encounter This Problem, Please Rotate the Potentiometer More than 10 Turns Counterclockwise before Using the Module to Adjust the Voltage Normally. Because the Default Output Voltage Is about 20V When the Step-down Module Is Shipped.