Gotv Digital TV Ariel +Free 10 M Cable

Low Signal Ariel - Works in areas of low signal. So you are Always guaranteed of high quality resolution on your TV.
Digital receiver antenna This antenna is
UHF AND VHF
signal receive that help your decoder or your digital TV  just connect
the antenna to the pole and position it facing the mask signal
distributor then connect to the decoder or digital and once the signal
if scanned you are ready to receive digital signal clearly.Digital
receiver antenna This antenna is UHF AND VHF signal receive that help
your decoder or your digital TV  just connect the antenna to the pole
and position it facing the mask signal distributor then connect to the
decoder or digital and once the signal if scanned you are ready to
receive digital signal clearly.Digital receiver antenna This antenna is
UHF AND VHF signal receive that help your decoder or your digital TV 
just connect the antenna to the pole and position it facing the mask
signal distributor then connect to the decoder or digital and once the
signal if scanned you are ready to receive digital signal clearly.
1. Assemble Your Gotenna
This is what the GOtenna looks like straight out of the box.
1
Pull the cable through the middle of the antenna grid.
2
Screw the cable onto the yellow plastic box of the antenna.
3
When secured, slide over the waterproof sleeve.
4
Clip
the green plastic box and the red plastic box on the antenna into the
green plastic clip and the red plastic clip on the antenna grid, until
they click. (Green connects to green and red connects with red.)
5
Place the U bracket through the middle of the antenna.
6
Place the first pole bracket over the U bracket with the flat side against the GOtenna grid.
7
Place
the outward facing pole bracket attached to the GOtenna grid against an
upright pole. Make sure that the down arrow on the yellow box is
pointing down and then fasten the second pole bracket around the pole
using the wing nuts provided.
8
Find
a clear site that has no obstructions between the GOtenna and the
signal transmitter. Point the GOtenna towards the transmitter. Slowly
move your GOtenna to the left or the right until the strongest signal is
found. You will be able to see this on the signal lever bar displayed
on your TV. Then fix your GOtenna in its position.
2. Install your decoder
1
Connect your decoder to the TV using the Audio and Video (AV) cables provided.
2
Connect the GOtenna to the RF IN plug on the decoder. if you have an HDMI cable, connect it instead.
3
Connect
the power supply unit to the decoder before inserting the other end
into the plug point. Then switch on at the wall (GOtv recommends the use
of a power surge protector).
4
Switch
the TV on and press the AV button on the TV remote control to go to the
appropriate AV channel. After 20 seconds the GOtv logo will appear,
followed by the set-up screen a few seconds later.
Note:
If the GOtv decoder does not complete scanning, it will automatically
take you to the signal detection screen. At this point you may need to
point the GOtenna in the direction of the GOtv transmitter - and move
the GOtenna until the signal is strongest. This is the point where you
should permanently fix your GOtenna.
Once you see the GOchannel your decoder is ready for activation.
ACTIVATE ONLINE HERE