MKS-BASE V1.4 3D Printer Control Motherboard Compatible Ramps1.4

MKS-BASE V1.4 3D Printer Control Motherboard Compatible RepRap Ramps1.4 With USB Cable

There is a new version V1.4 from 2016-6-15!!!

Feature:

1. It gather all function on one board, which solved the Ramps1.4 combination interface problem that easily out of order
2. Using 4982 as a motor drive, the SOP package, the effect of heat dispelling is better circuit board uses the high quality of 4 layer board.
3. Optimize heat dissipation and Ramp Is 2 layer board.
4. Using special supply , the 12v-24v input to solve the problem of Ramps voltage conversion of fever.
5. Accept 24V input. Under the same system can reduce the current hot bed to 1/4, effectively solve the problem of hot bed MOS tube heating.
6. The can use open source Marlin, configuration are exactly the same with ramps1.4 , can be directly replace ramps1.4 also can be connected directly to Ramps1.4, 2004 LCD control board and the LCD board (12864)



Note:

1. Before connect supply, please confirm whether the connect of positive and negative are right.
2. When connect the , do not plug motor drive for easily leading to burn. Also do not adjust the current in the motor is running.

Package included:

1 x MKS-BASEV1.4
1 x USB cable
,,,,,









a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a