Solar power 10A Solar Charge Controller 12V/24V Solar Panel Intelligent Regulator

Battery Voltage: 12V/24V, auto & Charge Current: 10A & Discharge. USB Output: 5V/2A【Avoid controller recognition errors: the battery must be connected firsT, then connect to solar pane】
Adjustable charge/discharge control parameters, settable operating modes of loads,Load Timer Setting ON/Off Hours
Multi-functional LCD display, dynamically display all the operating datas and working condition, can be conveniently switched working modes and parameter configuration.
PWM charge management. Extend battery life
Build-in short-circuit protection, open-circuit protection, reverse protection, over-load protection

Charge Controller Features:

1.Build-in industrial micro controller
2.LCD screen display
3.PWM charging mode
4.Dual USB Port
5.Build-in short-circuit protection
6.Open-circuit protection
7.Reverse protection
8.Over-load protection
9..Dual mosfet Reverse current protection

Controller Parameters:

1. Floating charge Voltage(HVD 13.3V-15V)
2. Recovery after under Voltage(LVD 11V-13.5V)
3.Under Voltage protection (RVD 9V-12.3V)
4.Load Mode(24hours,1-23hours,0hour)
5.Battery Option (GEL,LEAD-ACID,FLOODED)

MODEL: RBL-10A Charge Controller

Battery voltage: 12V/24V auto
Charge current: 10A
Discharge current: 10A
Max Solar input: <50V
Equalization: B01 sealed 14.4V
B02 Gel 14.2V
B03 flood 14.6V
Float charge: 13.7V(defaul,adjustable)
Discharge stop: 10.7V(defaul,adjustable)
Discharge reconnect: 12.6V(defaul,adjustable)
USB output: 5V/3A
Self-consume: <10mA
Operating temperature: -35~+60 degree C

Solar Controller System Connection:

1.Connect the battery to the charge regulator - plus and minus.
2.Connect the photovoltaic module to the regulator - plus and minus.
3. Connect the consumer to the charge regulator - plus and minus.
NOTE: The reverse order applies when deinstalling! An improper sequence order can damage the controller!