G2 Dual System Drift Car Gyroscope For 1/10 RC Remote Drif

The product information is as follows:

Name:G2 Dual System Assisted Drift Car Gyroscope 8.4V High Voltage Suitable for 1/10 RC Remote Drift Car Aluminum Case B
Changing output direction: After the gyro is turned on and initialized, press the sw button once quickly to switch between normal and reverse directions, Adiust this according to your servo and car lavout, The front wheels of the car should counter-steer in the opposite direction when the car is sliding sideways.
Changing Blue and Red LED modes: After the gyro is turned on and initialized, press and hold the sw button for 3 seconds to switch between blue and red LED mode. The blue LED mode is used to suppress steering servo wobble caused by high gyro gain.
Setting gyro end point limit: Adjust the transmitter steering EPA properly first! Do not use EPA that exceeds the car's physical steering limit. Power-off the car before the following steps.
Press and hold the SW button before turning on the power. Power on and release SW button when the Blue and Red LED flash together.

Hign-concerned Chemical:None
Wheelbase:Bottom Plate
Technical parameters:value 2
For Vehicle Type:Cars
Tool Supplies:Assembled class
Four-wheel Drive Attributes:Assemblage
RC Parts & Accs:Gyros
Use:Vehicles & Remote Control Toys
Recommend Age:14+y
WARNING:
1. The white wire on the harness cable is the signal wire. Please ensure the harness cable is connected correctly on the gyro before use
2. lnstall the gyro on a flat surface and away from the motor to avoid vibrations which affect performance.
3. During power turn-on, ensure other electronic devices do not emit strong vibrations which will cause gyro initialization to fail
The product appearance and printed words may vary depending on the batch, but this does not affect use.
Colour:B:Red
Material:Metal

Package Contents:
1 * RC Remote Drift Car G2 Dual System Assisted Drift Car Gyroscope

Only the above package content, other products are not included.
Note: Light reflection and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.