Adapter Card PCIe To SATA ESATA IDE PCB Network Converter C

Feature:
1. Comply with PCI-Express 1.0 a standard, support for Ultra ATA 133 hard drive, and downward support for Ultra ATA 100/66/33 standard.
2. The adapter card supports hard drives with a capacity of 137 GB or more (48-bit LBA mode).
3. Support 1 external ESATA interface and 1 internal SATA interface, the transfer rate can be up to 3Gb/s.
4. Support for RAID 0/RAID 1/RAID 0+1 mode, support JBOD, with various storage methods.
5. The operation is simple, insert the adapter into the corresponding PCI-Expres slot, read the drive disk and insert the hard disk to use.

Specification:
Item Type: Adapter Card
Material: PCB
Color: Black board
Chip: For JMB363
Transfer Type: PCIe to 2 internal SATA + IDE + 2 external ESATA (external ESATA and internal SATA can only use 2 at the same time, select by jumper, the default is 2 internal SATA interfaces)
SATA Transfer Rate: Up to 3Gb/s
Supports hard drives with a capacity of 137 GB or more (48-bit LBA mode)
1 IDE interface supports up to 2 IDE devices
How to Use:
1. Open the computer case and remove the rear block
2. Insert the adapter into the corresponding PCI-Expres slot
3. After installing the chassis, turn on the device, read the drive disk, install the drive, and then connect to the hard drive for use.

Package List:
1 x Adapter Card1 x Driver CD
Note:
Please note that the new type and old type of this product will be sent Ran-domly, and make sure you will not mind before ordering.