915 Generation 3D Printer Parts Pin 27 Tools Mini Upgrade Touch Breakout Adaptor Board for -10 5 3 Pro BLTouch

Improved design with wider power channels
With this adapter no wires need to be cut Simply connect this between your board and your cable attach the 3 bltouch wires and upgrade your firmware

Compatible with
3
3 Pro
5
-10 Mini
-10
Incompatible with
ANet A8
2
4
-8
you connect BLTouch's 3 pins per the labeling on the board
You must have a Bootloader flashed to your 3 Board in order to use this Support for that is not provided
Attention
The pin 27 board makes installing a bltouch or filament sensor fast and easy Normally you would need to cut the ribbon cable and solder into the pin 27 with the board plug and playafter firmware update
Make to check your wire configuration on your bltouch or filament sensor The new bltouch sensors should plug right into the board without depining the connector
Left to right Brown-Ground Red-5v YellowOrange-Signal
Disconnect lcd ribbon ext1 on the control board
Connect Ext1 to the pin 27 board
Connect bltouch to the 3 pins on the pin 27 board Left to right Brown-Ground Red-5v Yellow-Signal
Connect the pin27 to the main board Make to align the header pins from the pin 27 to the main board
ColourAs shown
MaterialPCMetal

Package Contents
2 x pin 27 board adapter board

Only the above package content other products are not included
Note Light reflection and different displays may cause the color of the item in the picture a little different from the real thing The measurement allowed error is - 1-3cm