915 Generation Ebike SW900 LCD Display Control Electric Bicycle Speed Meter Waterproof Plug Record Instrument ControlSetting 24-72V

Features 1 Display Function Speed display power-assisted gear display power indicator fault prompt mileage single mileage headlights and single driving time display
2 ControlSetting Function Power switch control headlight switch control 6Kmh boost control wheel diameter setting speed limit setting meter sleep setting backlight brightness setting voltage setting
3 Harness Description Red P meter power cord Blue VCC electric door lock wire Black GND negative wire Green Meter data receiving Yellow TX Meter data transmission
4 Meter Setting Function ①Long press the up and down ons of the meter to enter the meter

P01 Backlight brightness level 1 is the darkest level 3 is the brightest
P02 Mileage unit 0 KM 1 MILE
P03 Voltage level 24V 36V 48V
P04 0 no sleep other numbers are range 1-60 unit minutes
P05 Power assist gear 1-9
P06 Wheel diameter unit inch precision 01
P07 Number of speed magnets range 1-100
P08 Speed limit speed percentage range 0-100% 100 means speed 100%
P09 Zero non-zero setting 0 zero 1 non-zero
P10 Drive mode setting 0 power-assisted drive the handle is invalid
1 Electric drive by turning the handle to drive the is invalid at this time
2 Power-assisted drive and electric drive coexist at the same time
P11 Assist sensitivity setting range 1-24
P12 Assist intensity setting range 0-5
P13 Power-assisted magnet type setting There are three types of 5 8 and 12 magnets of which 5 and 8 are single Hall power-assisted sensors
②Setting 12 is used for dual Hall assist sensors
P14 This function is yet
P15 This function is yet
P16 ODO reset setting Long press the up on for 5 seconds ODO reset
Features For Ebike
Pment on Vehicle Handle
colorBlack
Materialplastic

Package Contents
1 x display

Only the above package content other products are not included
Note Light reflection and different displays may cause the color of the item in the picture a little different from the real thing The measurement allowed error is - 1-3cm