915 Generation WIFI Signal Scanner 24G5G WIFI Signal Usage Analyzer Router Management Assistant WIFI Signal Tester

Built-in 600mAh lithium battery the working current is about 160mA and the standby time is about 4 hours
Built-in lithium battery charging management circuit The charging time is about 2 hours
Use TYPE-C interface to charge very convenient
The charging voltage is 5V When charging the red light indicates that it is charging and the green light indicates that it is fully charged

Instructions
1 Long press the on to power on long press again to power off
2 Press the on once to start scanning press the on again to pause scanning
3 The waveform on the top of the screen shows all the wifi signals in the 24G frequency band ly only the wifi signal with the strongest signal is displayed However if there are multiple signals at the same frequency point they will be displayed in numbers below the corresponding coordinate scale For example if the number 5 is displayed it means that the same frequency point is occupied by 5 wifi The waveform below the screen corresponds to the waveform of the 5G signal The interpretation method is the same as above Since there are more frequency points of 5G signals there is no way to mark all the frequency points on the coordinate scale
Type WIFI signal scanner
Interface TYPE-C
Charging voltage 5V
Material ABS
colour White

Package Contents
1 x Host
1 x TYPEC Charging Cable

Only the above package content other products are not included
Note Light reflection and different displays may cause the color of the item in the picture a little different from the real thing The measurement allowed error is - 1-3cm