Fk 13 Amps Fridge & freezer guard

The Fridge guard is an overvoltage protection device rated at 5 Amps. The Fridge guard will disconnect if the mains go above the upper limit and re-connect automatically after the supply returning and remaining below the upper limit for the duration of the wait time.

KEY FEATURES

• High Voltage disconnect
• Low Voltage protection
• Microprocessor control
• Spike/surge protection
• Power back surge protection
• Lightning protection
• Heat resistant hard ABS plastic to withstand overheating
• Safety shuttered sockets
• For all electrical devices
• Both indoor & outdoor

1. Make sure that your load does not exceed the rating of the Fridge guard which is 5 AMPS. If this is exceeded, the Fridge guard may be damaged, and the warranty will be void.

2. Plug the Fridge guard into the mains and plug your appliance into the Fridge guard.

3. Do not connect more than one appliance to the Fridge guard.

4. On first switching on, the red LED will indicate and there will be no output while the Fridge guard monitors the mains. If the mains level is acceptable, the Yellow LED is lit indicating that the Fridge guard is in wait mode.  At the end of the wait time (30 seconds), and if the supply is below the upper limit, the green LED goes on and the load is connected.

5. It is recommended that the Fridge guard is kept switched on, and the appliance switched on and off as required, to prevent activating the time delay every time the appliance is switched on