125KMH 85mm Speedometer Gauge Pulse Speedometer 200KMH Odometer Pulse Signal with Indication Light for Diesel Gasoline 12V24V

85mm Analog Pulse Speedometer,Pulse Signal

Application: Motorcycle/Marine Boats/Truck/Bus/Electric-Vehicle/Three Wheeler,etc.

Feature:

Electronic Speedometer (stepper motor)
Speed Ratio (impule/km) Adjustable
OverSpeed Buzzer Alarm (Value Adjustable)
Indication Light (Left, Right and High Beam)
Hall Effect Speed Sensor Support
Installation Diameter: 85mm
Speed Range: 0~125KM/H or 0~200KM/H
Mileage range: 0-99999.9KM
Reverse polarity protection and anti-fogging performance
Working Voltage:12V/24V
Working temperatures: - 40 to 85°C
IP67 Waterprof

Connection:

1.GND
2.ING (12/24V)
3. Speed Pulse Signal
4.Voltage Output(8V )
5. Yellow Backlight ( )
6. Left Turn ( )
7.Right Turn ( )
8.High Beam( )

How to set the gauge:

1.Cut an 85mm (3 3/8") hole in the panel (II) allow a clearance of . behind the panel.
2.Remove fastening ring (I), insert gauge from front. Tighten gauge (III) using fastening ring ( I)
3.Connect cables according to the diagram. Choose yellow background light.

Function Select： “PULSE”,“LEARN”,“ODO”，“BUZZ”

Press and hold on the button at the back, then turn on the power supply.
The LCD will show PULSE, LEARN, ODO, BUZZ, etc.
You can select the function to be set after release button.

1.“PULSE” (change speed ratio pulse/km)

After selecting “PULSE”, the LCD will show for example “P 5000” (5000pulse per km) after 3 seconds.
Press the button to change the flashing digit (K Value) in the LCD (from 1000 to 65539)
You can select “PULSE” again to confirm the setting is done.

2.“LEARN”(Learn and record the speed ratio of sensor/engine)

If you do NOT know the speed ratio of sensor/engine, then you can use “LEARN” mode to confirm
the speed ratio.
Firstly connecting the Speed Sensor with our Speedometer, then Enter “LEARN” MODE:
After selecting “LEARN”, the LCD will show for example “0” (pulse per km) , then drive the vehicle
for 1000m (1km), then LCD will show the correct Speed Ratio

3. “ODO”(total odometer)

After selecting “ODO”, the LCD will show for example “5000” (5000 km) , press the button to change
the flashing digit from 0 to 99999 to set the target odometer value.

4.“BUZZ”(change overspeed buzzer alarm threshold value)

After selecting “BUZZ”, the LCD will show for example “B 80” (buzzer will be on when speed over
80km/h), press the button to change the flashing digit from 10 to 240 to set target overspeed
buzzer alarm threshold value.
(Remarks: No.3 function is not ready in the prototype sent to BESTAS, but will be ready in mass
production.)

Please noted: After setting, you should disconnect both Power and GND, and then reconnect the two cable, then it will save the setting. If you just cut Power , then it’ll not work properly

Package:

1 X gauge( no GPS Antenna)