13S 48V 35A PCB BMS Protection Board Li-Ion Lithium Battery Charger Lipo Cell Module with Balance for Battery Cell Pack

High-accuracy voltage detection circuit, fine workmanship and durable.
With Over-discharge protection, overcurrent protection, overcharge protection, temperature control protection function, safe and reliable.
The protection board is for 13 series cell Li-ion batteries, it can be used for 3.7V ternary batteries, manganese acid batteries and cobalt acid batteries.
It has balance function which would ensure each battery cell being fully charged at same time.
It is suitable for electric car, electric power assistant car, skateboard car, inverter, etc. Continuous Discharge Current: 35A
Momentary Discharge Current: 100A
Charge Voltage: 54.6V
Charge Current: 8A(Max.)
Overcharge Protection
Overcharge Detection Voltage: 4.28±0.05V
Overcharge Protection Delay: 100mS
Overcharge Cancel Voltage: 4.08±0.05V
Over-discharge Protection
Over-discharge Detection Voltage: 2.55±0.08V
Over-discharge Detection Delay: 50mS
Over-discharge Cancel Voltage: 3.0±0.1V
Cell balance voltage: 4.2±0.025V
Cell balance Cancel voltage: 4.2±0.05V
Cell balance current: 60±5mA
Overcurrent Protection
Overcurrent Detection Voltage: 150mV
Overcurrent Detection Delay: 15mS
Overcurrent Protection Current: 120±5A
Protection Cancel Condition: Disconnect Load Short Circuit Protection Short
Circuit Protection Condition: Outside Load Short Circuit Short
Circuit Detection Delay: 200uS
Protection Cancel Condition: Disconnect Load Internal Resistance
Main Circuit Conduction Internal Resistance: less than 15mohm
Self Power Consumption Working Current: less than 50uA
Sleeping Current(Battery Over-discharge): less than 10uA
Operating Temperature: -30Celsius-+80Celsius
Weight: 52g
Size:69 mmx51.5 mmx10 mm/ 2.72inch x2.03inch x 0.39inch
Colour:silver
Material:PCB Package Contents:
1x 13S 35A lithium Battery Protection Board Only the above package content, other products are not included.
Note: Light and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.