3.6V Battery Supported Outdoor IR R Pocell Automatic Gate Garage Door Infrared Beam

Speicification:

Working voltage

Transmitter : 3.6V (14250lithium battery , battery not included ) Receiver : 12-24V DC

Working current

Transmitter < 85µA, Receiver < 30mA (24V DC)

Photocell wavelength

940nm

Angle of emiion

≤±5°

Receiving range

> 12m

Relay contact loading capacity

1A/30VDC

Size

100*40*35mm

Safety Instruction

1.For security, please read the user manual carefully before initial operation;

2.ThThisis photocell is without any fuse,so Please make sure the power is off before installation;

3.Only used this system that do not cause any danger life or property duringthe running failure or its security risks eliminated;

4.Please guarantee the products used in effective working range

4.1Installation instruction

Receive module J4 in above picture is the option switch for NO and NC of photocell switch.

4.1.1When the short circuit cap on NO,it is normally open.

4.1.2 When the short circuit cap on NC,it is normally closed.

4.2 Installation

4.2.1 The photocell should be installed more than 20cm above the ground (to avoid reflection), and the distance between emitter

and receiver should be more than 50cm.

4.2.2 End user should install the photocell receiver on the back of the direct sunlight or other strong light source(±5°) to keep photocell work well steadily.

4.2.3 Avoid installing other infrared photocell emitters within the effective distance of receiver.

4.2.4 If the end user need to install other photocells in one same straight line , the receivers could be installed in the two ends and the emitters could be back-to-back installed.

4.2.5 Stable installation could avoid the signal of emitter and receiver skewing due to lightly vibrate and the malfunction.

4.2.6 When the product is install in some place with angle , end user could adjust the PCBA to make the installation better.

4.2.7 Connect the power after the inspection, when short circuit cap at NO, After the battery is installed on the LED lamp of the transmitting module, the LED lamp lights up for 0.5 seconds and then goes out, receiver module LED turns on, receiver module contact at off; when make the cap of emitter and receiver in alignment, receiver module LED is off, NC/NO is on ;when something or someone shelter the r, receiver module LED will turn on , NC/NO contact is off. When short circuit cap at NC, the state of NO/NO is opposite to the above phenomenon.

About shipping
Shipping and Packaging All itwill be double checked and well packed before sending.Itwill be dispatched within 2 business days after buyers pay for the order. It usually takes about 14 to 18 working days for delivering the package to the destination(for e areas,it may take a little longer). 

Special Announcement:
Please fill in the correct and detailed consignee, address and phone number in the order. For fast and correct delivery.If you do not receive order within 30 working days,please feel free to contact Customer Service before leaving Negative and Neutral Feedback, we will do our best to help you resolve the problem.TaxNo, you will only pay what is quoted as total cost at checkout, no more. You are not expected to pay any additional duties ores. If you are asked by Customs or our logistic partner to pay duties, please contact our Customer Service .

Your 100% satisfaction is very important to us
If the product is not on good condition, You can return this product within 14 working days, please contact customer service center before returning.FeedbackYour satisfaction is our first priorityIf you receive the order and it is in good condition,we would be grateful if you would leave us 5 star Positive Feedback for the transaction.