Car Embl 5D Car Front Grille Trunk Logo LED Light Retrofit Light For Fit Odyssey CR-V ACCORD CIVIC Honda LED accessories

Before purchasing, please measure the size of your car emblem.Characteristics:1. Each product has 1 color. This light must be connected to the power connector of the night plate light. During the day when the car logo light is off, it is the same as the car logo. When the plate lighting at night is turned on, the LED beacon lights will also light up.2. The LED lamp is waterproof and dustproof, with a service life of 100,000 hours.3. Adopt high quality car double-sided adhesive, the adhesion is extremely strong and ble!Specifications:1. Fit for Honda2. Wiring length: 0.25.Package includes: 1 piece4. Note: If you have any questions, please contact us and we will reply you within 24 hours.Tools prepared before installation:Prepare the following tools: 1. Flat screwdriver 2. Cro screwdriver 3. Electrical tape 4. Towel 5. Installation instructions:There is double-sided tape attached to the back of the product. Please check the size of your car rear emblem before purchasing. When you install it, you need to remove the car rear emblem and paste this product. If the car has no holes, you need to the holes and connect the wires to the positive and negative poles of the 12V power supply in the car.1. First, put a towel next to the trunk logo (to avoid scratching the body), and use a flat screwdriver to pry out the logo2. Remove the double-sided adhesive tape from the old car body logo, gently pull out the logo, and clean the residual double-sided adhesive tape.3. Use a cro screwdriver to remove the partition board inside the trunk, pay attention to the buckle, and carefully remove the sound insulation board.4. Install the logo light. The logo light power line paes through one of the logo positioning holes and into the trunk. Peel off the one-sided adhesive on the back of the car signal lamp, stick the car signal lamp to the body while pulling the wire, and pre it firmly.5. Please turn on the power supply after installation of the logo lamp. Connect the power supply of the taillight to the vehicle logo lamp, so that when the small night lamp is turned on, the vehicle logo lamp will also turn on at the same time. And find the rear plate lamp power connector.6. Unplug the plug, punch a hole in the positive and negative poles, expose the wire core, connect the wire according to red to red and black to black, and don't forget to wrap it with insulation tape, and finally connect the plug of new! Reps the trunk lid insulator.