Carbon Monoxide WiFi Detector Tuya Smart Life AWifi Household Gas Alarm Remote Battery Powered CO Detection Alarm Basic

Specifications:

Introduction

This device is a battery-powered Tuya WIFi acontrol carbon monoxide alarm with an advanced electrochemical sensor for domestic use. Please note that this device does not detect smoke, heat, flames or other hazardous gases.

1. Preheat After the alarm is powered on, the alarm will enter the warm-up state for 1

minute; the green and yellow LEDs will flash, at the same time, the LCD will cyclic display numbers 1～9, and the LCD will display 0 at the end of thewarm-up, indicating that the alarm has entered the normal working state;

2. Testing Test your alarm by preing the Test/Hush on until the unit beeps once and the red LED flashes once, then release the test on. The blue backlight will be lit, and the unit will proceed to beep 4 times with the red LED flashing 4 times.

After 5 seconds of silence, the unit will beep 4 times with the red LED flashing 4 times again. It is then followed by a single beep and the red LED flashing once.

The LCD display will show the highest CO recorded since the previous test, followed by "---"then "PAS"and finally "0".

3. Hush on When the CO detector is sounding an alarm after a suspected false alarm, you can pre the Test/Hush on and the detector's alarm sound will beep intermittently, the blue backlight will be off and the red LED will flash once every 5 seconds. The detector will resume its normal monitoring status after 5-15 minutes. If the CO level is still at a dangerous level, the alarm will sound again.

4. CO alarm levels The CO01A Battery-Operated Carbon Monoxide Alarm is programmed to sound an alarm at the following CO concentrations within the time periods listed:

50m for 60-90minutes,

100m for 10-40 minutes, and 300m for 0-3 minutes.

When CO is detected and the alarm sounds, the CO concentration will be displayed on the LCD and a blue backlight will be lit. The red LED will flash and the alarm will iue 4 short beeps, repeating the cycle every 5 seconds

.

Network acce settings

Open the 'Tuya Smart" or "Smart Home" App, select the "Smart Home"page, and click the " Add Device" on;

On the device addition page, click the "Scan" on in the upper right

corner to scan the QR code below;

Follow the instruction step by step to complete the paring proce.

You can choice to paring the network by manual operation al step:

Paring proce(EZ Mode):

Step1: Open the Aenter into "My Home" ,click "Add Device" ;

Step2: Select "Security & Sensor",and select "Alam (Wi-FiI";

Step3: Power o the device, Quickly pre the on four times until

the LED indicator light rapidly blinks.Confrm and Click""

Step4: Wait for the device to configure automatically.The paring

proce is within 3 minutes ;

Step5: After the configuration is succeful, the indicator light stops

blinking, and the Ajumps to "Added sucefully". Click "Done" to

finish the paring proce.

IF failed to pairing the alarm, please try again or choose the AP Mode

to try it.

Power Supply ：9V battery

Sensor Type: Electrochemical

Safety Standard: Conforms with EN50291:2010

CO Sensitivity:50ppm: 60~90 minutes

100ppm: 10-40 minutes

300ppm: