For Toyota RAV4 XA40/XA50 2013- Car Head Up Display HUD Electronic Safe Accessories Driving Screen Alarm System

Car Head Up Display:

For Toyota RAV4 XA40 2013-2018

For Toyota RAV4 XA50 2018-2023

- Reflecting Car Informations On the Windshield -

- Safe Driving Screen -

Special Notice:

Only Fit the car of Left Hand Drive Country.

Please don't order for Right Hand Drive Country Buyers .

Please check the front speaker's outline to see if our HUD is the same as it before order.

Thank you.

HUD has 21 features that are impeccable:

1.   Multi colour design es the screen easier to read highlight ant details for quick viewing;

2. The use of nanotechnology to eliminate unwanted reflections ing the information easier to read;

3.  Ability to display a huge range of car statistics including: speed, engine rotational speed, water temperature, battery voltage, instantaneous consumption, average consumption, local time,single driving time,mileage measurement, shift reminder, fatigued driver reminder, low voltage alarm, high temperature alarm, speed alarm, engine fault alarm, fault code elimination, ability to change units e.g. Kilometre/mile

4.  Auto power on and off with the vehicle

5.  Automatic and manual brightne adjustment mode.

It can let us keep ck of all kinds of data on the vehicle dashboard, and can grasp it in real time without looking down, avoiding ffic accidents caused by disction while driving.

Concealed Design Deamle Fit

The car is designed to be built by the car, highly matched, and directly reps the car.

1.Ensure your vehicle is II compatible or EU.

1. Check around the area under the steering wheel for an plug

2.Contact your vehicle manufacturer or search online

3.  Open the bonnet and look for a II compatible sticker (this is NOT on all II compatible cars, therefore isn’t a deciding factor)

2.Locate the 16 pin diagnostic link. This is usually located in the area under the steering wheel.

3.Start vehicle’s engine and ensure power switch is in the on position.

4.HUD will power on with engine

1. If the HUD displays vehicle voltage, consumption, speed and rotational speed the unit has installed correctly.

2.Failing the above: Wait up to one minute for to sync and confirm cable is plued in properly