HW-399 4-channel Optocoupler Isolation Module for Arduino high and low level expansion board electronic building blocks Red

This board is helpful for connecting digital systems (like a 5V microcontroller) to a high-voltage or noisy system.
This board electrically isolates a controller from the high-power system by use of an opto-isolator IC.
This IC has four LEDs and four photodiodes built-in. This allows the low-voltage side to control a high voltage side.
We often use this board to allow a microcontroller control servos or other motors that use a higher voltage than the TTL logic on the (3.3V or 5V), and may cause electromagnetic interferance with our system as the motors turn on and off.

Color: Red
Material: metal
PCB Size:25mmx26mm
This board will isolate the systems, creating a type of electrical noise barrier between devices.
This breakout board uses the TLP281 optoisolator and discrete transistors to correct the logic.
Comes with four channels. Great for use in noisy circuits where signal lines require electrical isolation.
A normal LED opto-isolator will invert the logic of a signal.
We threw some transistors on this compact board to correct the inversion.
What you put into the IN pins, will be replicated on the the OUT pins, but at the higher voltage (HV).

Package Contents:
1 x HW-399 4-channel Optocoupler Isolation Module

Only the above package content, other products are not included.
Note: Light shooting and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.