LCD Display Heat Gun Hair dryer Construction 2000W Hot Air Gun Thermal Blower for Shrink wrapping DIY Tools

Product feature

one Grille air outlet design, uniform air supply, strong and powerful

two Double heating wire, overload protection, rapid temperature rise, not afr of overload

three PP + GF30 body shell + ABS side cover black-and-white color matching design, more heat insulation, fall and scratch resistance

four Two speed wind speed regulating switch and steple temperature regulating knob are designed to adjust the temperature according to their own need

five Skobo motors ed from Japan have uniform and stable operation and longer service life

6.1.0 M2 1.8m rubber power cord, more high temperature resistant, more wear-resistant and more corrosion-resistant.

7. ed insulated heating core is treated with high temperature and special liquid , and its service life is 5 times that of ordinary heating core.

8. Blue light high-definition LED display, high-definition anti dazzle, strong light working environment is clearly visible.

Precautions for safe operation

1. Please connect the power supply according to the voltage indicated on the tool.

2. When using tools at heights, be sure to hold the tools tightly at any time.

3. Do not p the tool before it stops completely.

Safety precautions of hot air gun

1. Do not use the hot air gun as a hair dryer.

2. Do not direct the hot air blower to people or animals.

3. Do not use near ins or es.

4. Do not block or cover the hot inlet and outlet.

5. Do not touch the nozzle when the hot air gun is used or just after use. The handle of the hot air gun must be protected

Keep dry.

6. The hot air gun can be stored only after it is completely cooled.

Maintenance and repair

Do not use turpentine, mixture, oline or the same for cleaning.

1. After using this heat gun, please set the switch to zero and wait for 10 seconds, and then wait until the delayed shutdown function is completed

Cut off the power. This function will blow out the hot air remaining in the air duct. At this time, the hot air gun can be hung vertically

Sight and inverted buckle on the flat working surface.

2. When storing the hot air duct, please confirm that the hot air duct has been completely cooled.

3. Regularly remove the dirt accumulated at the air inlet and keep the air inlet and outlet clean.

4. Check all extended insulated wires. If damaged, please rep them immediately. Do not use damaged insulated wire

Edge wire, because it may be injured by electric shock if touched.

5. All maintenance must go through an authorized service center or other qualified service organization to ensure security

Integrity and reliability.