MR16 Pool Spotlight COB LED Underwater Lighting 7W DC12V for Fibergl and Concrete Pool IP68 Waterproof

Note

1. Ensure that the voltage the lamp receives is never greater than 12V.2. And e sure you connect DC12V to our lamp, not AC12V.3. Buyer needs to buy dimmer separately.If buyer doesn't have dimmer, the lamp also can illuminate after connecting DC12V nsformer, but it can't be dimmable, because no dimmer.

Input voltage: DC12VLight source: 1 piece of COB LED MR16 SpotlightWatt versions: 7WLamp body material: PlasticLamp dimension: D94xD58xL110mmEmbedded part dimension: D74xH115mmLamp waterproof grade: IP68 ( can be put into water directly ).Dimmable: Yes ( but it doesn't include dimmer )Length of power cable: 1 meterLife Span: 50000 hoursColor versions: Warm White 3000K, Daylight white 4000K

Knowledge

It can be used for concrete pool, fibergla pool.

Installation for concrete pool

1. Open a suitable size hole on pool wall as embedded part.2. e inside of hole waterproof in case water leaks outside from concrete wall.3. Get main power cable through embedded part.4. Insert embedded part in the hole, and fill cement between wall.5. Connect main power to the lamp and e the connector waterproof.6. Switch lamp into embedded part.

Installation for fibergla pool

1. Open a hole on fibergla pool.2. Install the lamp go through the wall, and keep one waterproof rubber inside of lamp.3. Put other waterproof rubber ring at the back side of lamp, and fix screw tight.