Network Cable Tester RJ45 RJ11 LAN Internet Cable Remote Test Tools

Network Cable Tester RJ45 RJ11 RJ12 CAT5 UTP LAN Cable Tester Detector Remote Test Tools Networking

• The product is the pricewithout battery,
• It adopts automatic scanning method, rapid test, streamlined appearance, and ergonomic design. Smooth and concise lines, drop-proof, light-proof design, more in line with on-site construction.
• Test cable: RJ11, RJ45
• Power supply: DC 9V laminated battery
• Power consumption: 25MA
• Total weight: 150g

Function:

1. Test the twisted pair 1, 2, 3, 4, 5, 6, 7, 8, and G wire pairs one by one (pair), and can distinguish which one (right) is wrong, short circuit and open circuit.
2. Switch ON is the normal test speed, "S" is the slow test speed.
3. Two matching jumpers (such as 110P4-RJ45) need to be connected to the tester if testing the patch panel and wall mount module.
4. Coaxial cable test: If the cable is good, the BNC lights at both ends will flash green at the same time.

Twisted pair test:Turn on the power and insert the network cable plugs into the main tester and the remote tester respectively. The indicator lights of the host will flash from 1 to G one by one, as shown in the figure below:Main tester: 1-2-3-4-5-6-7-8-GRemote tester: 1-2-3-4-5-6-7-8-G (RJ45)1-2-3-4-5-6------(RJ12)1-2-3-4----------(RJ11)If the wiring is abnormal, it will be displayed as follows:

• When a network cable such as line 3 is disconnected, the main tester and remote test terminal No. 3 lights will not light up.
• When several lines are unavailable, several lines will not light up. When the network cable is less than 2 lines connected, the light will not light up.
• When the two ends of the network cables are out of order, for example 2, 4 wires are out of order, the display is as follows:

1. The main tester remains unchanged: 1-2-3-4-5-6-7-8-G
2. The remote test terminal is: 1-4-3-2-5-6-7-8-G

• When two network cables are short-circuited, the main tester will not light up, and the two cables that are short-circuited at the remote test end will light up slightly. If there are more than three (including three)When short-circuited, the lights of all the short-circuited wire numbers are off.