Push Switch Light Bar For Mit Subishi Pa Jero Tri

Specification:
Voltage: DC 12V
Current: 3A
Color: Black
Material: Plastic
Size: 33x55x16mm
Wire Length: 20cm / 7.87inch
Manufacturer Part Number: SWM207B

This Switch Suits the following models ONLY:
Mitsubishi Mirage LA Series
Mitsubishi Outlander ZK Series
Mitsubishi Pajero Sport QE Series
Mitsubishi Triton MQ Series
Mitsubishi OEM Replacement Push Switch

Feature:
Mitsubishi OEM Replacement ON-OFF Push Switch.
Single Pole Single Throw ON-OFF PUSH switch.
Black hard surface.
Laser etched Legend.
Dual LED lights in Yellow & Green.
Rated at 3amp 12V.
Upper light is ON when the switch is pressed IN.
Lower light can be wired to separate dash light circuit.
All symbols are Laser etched directly onto the switch face using modern high Tech laser engraving equipment to ensure long image life.
This 12 volt push switch from is a single throw ON-OFF switch designed to operate your 12 volt accessories. it has a face surface size of 35 mm x 20 mm, length of 55 mm and uses the original mounting hole of the vehicle.
This switch is an aftermarket switch that locks into your existing panel super easy to install in less than 10 min's.

Package Included:
1 x Push Switch

Notice:
- Please allow 1-3MM differs due to manual measurement.
-The switch is an electronic switch rated at 3amp's. Therefore in ALL cases the accessory MUST be wired through a fused relay.