XRNKEY12V Auto Car Entry Start System One Start Stop Engine Push on Vehicle Alarm PKE e Auto Start dropshing

Auto car 12v keyle entry system one start stop engine push on car alarm system

Notice:

1. This model is working for 12v low and medium cla cars only, can not work for high cla cars of US and European.

2. If your car has immobilizer, you need to buy bypa or other way to avoid immobilizer.

3. For opening trunk function and e start engine (only avaiable for model 3) ,please add relay for your car.

Three models for option:

Features:

-ligent one key to start the system, using smart s, can provide a key to start / flameout, convenient and simple.

-PKE keyle entry, automatic r switch lofunction, near the car 2 meters, the automatic r unlock.

-There is a e start / flameout, countdown ten minutes off function.

-Summer cool car, winter warm car, no longer bear the car when the uncomfortable.

-With the identity function, the e control is not able to start normally.

Key Operation:

-Do not pre the brake, short pre to open the ACC sound, then pre the "on" dasard, the indicator light fes, then short pre off, you can cycle operation.

-Brakes, short pre, the system ignition start, light light.

-When the flame is turned on, the brakes are short preed and the system is turned off.

-Step on or not brakes, pre, the system can let go ar the ignition, light light.

Q & A :

1.How to find the ACC wire?

Please rearrange the 6P cable, ar you twist the key to the first gear position (you can listen to music at this time), measure the line that has electricity on your car is the ACC line.

2. For your 6p cable, but my car is only 5p. what can i do ?

If your car is a 5P line, the right connection is normally 1 power line, 1 ACC line, 2 ON lines, and 1 start line. If you didn't follow this step, it means you got wrong installation. pls recheit again. and pls remember 2 ON lines need to distinguish which is ON1 line and which is ON2 line. If the two ON lines are always charged at the time of startup, you need to connect the two ON lines in parallel.

3. How to tell the wire ON1 and ON2?

If you test these two ON lines at startup, one of the two that always has power is the ON1 line. And If the other one has instant power is the ON2 wire.