Temperature Digital Controller Thermostart

P0 cooling and hIv. Instructions

eating mode

 

Please set high temperature start to C for refrigeration mode

 

Low temperature start is in heating mode, please set it as H

 

P1 error setting

 

In heating mode (H) : when the measured value is less than or equal to the set value -- return difference, start the output heating until the set value stops

 Under refrigeration mode (C) : start the output refrigeration until the set value stops when the measured value set value + return difference P2 maximum setting range: the maximum value at the setting temperature shall not exceed this value P3 minimum setting range: the minimum value at the time of setting the temperature shall not be lower than this value 

P4 temperature correction.

 When there is a deviation between the measured temperature and the standard temperature, this function can be used for correction. The corrected temperature = the temperature before correction + the correction value P5 delay start time unit: minutes When controlling the refrigeration of the compressor equipment, the delay time can be set according to the need. When the controller outputs, the equipment will not start immediately. It needs to start after running the set delay time

 P6 high temperature alarm

 When the measured value is greater than this value, the screen will display -- -- and sound alarm, and force the output to be disconnected. 

P7 data lock function

 Open the data lock to keep the current setting unchanged. At this time, setting temperature and functions are invalid. If you need to modify, you need to close the data lock function. 

P8 restore factory Settings

 Long press SET to switch to P8, press SET once to SET on, and press Rst to restore factory Settings You can also press and hold the +- key to restore the factory Settings.