High head water pump

Start by identifying where the water needs to be moved and how high it must lift. Then choose a high head submersible pump with the right horsepower (5.5 HP, 7.5 HP or 10 HP), a 2 inch outlet, and a three phase motor for reliability in irrigation and water transfer tasks. Premier offers models up to 100 m lift in the agriculture-grounds-management category, so match your maximum head to the pump you select. Finally, consider whether you are pumping clean water or dirty water, as this affects intake filtration and maintenance planning.

The 100 m lift is the maximum vertical height the pump can push water, but the actual flow decreases as the head height increases. As lift approaches the pump’s limit, the available flow diminishes due to the head pressure required to overcome gravity and friction in the piping. In practical terms, choose a model with enough head to exceed your worst case height while allowing for some margin in your piping losses. Premier high head pumps in the agriculture-grounds-management range come in 70, 90 and 100 m options with 2 inch outlets and three phase motors to suit different sites.

Yes, the intended use guides the head and power you need. Farm irrigation often requires reaching higher elevations, so a higher lift and horsepower (for example, 10 HP models delivering up to 100 m) can be ideal. For drainage or rapid water transfer across flat ground, a lower lift model (such as 5.5–7.5 HP) may suffice, keeping the 2 inch outlet and three phase design ready for heavy duty work. All Premier high head pumps are built for water transfer in agriculture and share the same reliable 2 inch outlet and three phase motors.

Install the pump with secure mounting and a proper electrical supply, preferably three phase if your area supports it. Keep the inlet screened and free of debris, and avoid running the pump when there is no water to prevent dry‑run damage. Regularly inspect seals, cables, and connections, and ensure the discharge piping is clear and fitted to the 2 inch outlet. Following these steps helps Premier high head pumps used in agriculture stay reliable in water transfer tasks.

Match the required vertical head to the pump’s lift capability. Premier offers 5.5 HP models up to 70 m, 7.5 HP models up to 90 m, and 10 HP models up to 100 m, all with a 2 inch outlet and three phase motors for water transfer. When selecting, also account for piping friction and any fittings that reduce flow, so you don’t oversize the pump beyond what your site needs. This ensures you get the right balance of head and flow for your agricultural tasks.

If performance drops, start by checking the power supply and ensuring three phase wiring is correct. Inspect the suction inlet for debris and verify there are no air leaks in the piping. Check the discharge line for blockages and listen for abnormal noises that might indicate worn impellers. If issues persist, consult product manuals for Premier high head pumps in the agriculture category or contact a qualified technician.